You can't possibly get the work done faster than by using this revolutationary Bar Puller which forms a single unit together with the part-off tool shank:

• it clamps the bar instantaneously after cut-off and spindle stop
• it pulls the bar into its new position simultaneously with the tool's retraction for automatic tool change.

Shank-application:

The fixing plate is fitted between the tool holder and the upper side of the part off square tool. The frame is fitted to the fixing plate.

Blade-application:

The fixing plate fits different sizes and brands of tool holders and is screwed on the tool holder. The frame is fitted to the fixing plate.

Adjustment of pulling plates

The pulling plates are pushed within the grooves (in the direction for the arrows) into the desired diameter within the Frame's range of 30 mm. Adjust the pulling plates to a diameter of 0,1 mm to 0,2 mm less than the bar diameter. The pulling plates are hardened and profile ground for best performance.

- Cut off  

- After cut-off the spindle is stopped   

- Pullex advances a little behind the bar centre for gripping the bar   

- The chuck jaws are unclampled and the bar is pulled out into the new cutting position

Pullex Crocodile System comes with the following three parts

• 1 x Frame (C30 or C60)
• 1 x Fixing Plate (Shank or Blade type)
• 1 set Pulling Plates (PFD-1)

Square shank part-off tool

1. When you have a shank part-off tool to be mounted on a tool holder you shall use the fixing plates with a flange together with the part-off tool in the tool holder.

2. When you have a square shank part-off tool and there is no space for the flange, you should use the fixing plate without a flange. This is a frequent occurrence when mounting the square shank part-off tool directly on the turret.